Not signed in (Sign In)

Welcome, Guest

You have reached the Lom Lab Protocols Resource, where lab protocols are stored, annotated, and discussed.

Please note that you must apply for an account and/or sign in before you can post a new protocol or comment on an existing one. You do not need to sign in to browse the protocols, however.

If you are interested in posting a new protocol, please be sure to read the Before You Post notice to ensure that our protocols remain standard. Thank you, and enjoy your visit!

 
Lom Lab Home

Vanilla 1.1.2 is a product of Lussumo. More Information: Documentation, Community Support.

    • CommentAuthorjuruble
    • CommentTimeJun 25th 2007 edited
     

    This protocol explains how to: use the the pulling machine to pull pipettes or needles.

    Protocol revised: 4/16/2007

    Protocol written by: Julie Ruble


    See picture of pulling machine, below, for reference while reading this protocol.

    1. Place long pipette (or glass filament, if you're pulling needles) in top clamp and position so that the wire coil hits the pipette where you want it pulled.
    2. Pull up bottom clamp as far as it will go and tighten.
    3. Set Heat #1 and Pull numbers (see side of machine for "recipes" or just experiment until you find a combination you like).
    4. Turn machine on and hit "pull" button.
    5. When finished, carefully remove pipette -- glass can be HOT and still look the same! Turn machine off.

    puller machine

    • CommentAuthorkilang
    • CommentTimeDec 10th 2007
     
    For pulling pipettes by hand (with the bunsen burner):

    Hold both ends and place the thin part of the pipette in the tip of the flame. I had the most success when I rotated it so all sides heated evenly and pulled once the heated section became soft. I began pulling the ends apart at the same time that I began pulling it out of the flame. The complete motion looks more like a 'V' than a 'Y'.
    • CommentAuthorelpitts
    • CommentTimeDec 16th 2010
     
    The needles will be more pointed and with thinner tips the higher the heat and the higher the pull settings.